Altman SPECTRA Series 사용자 설명서 - 페이지 9
{카테고리_이름} Altman SPECTRA Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Altman SPECTRA Series 15 페이지. Uv led
Altman SPECTRA Series에 대해서도 마찬가지입니다: 운영 매뉴얼 (11 페이지), 프로그래밍 매뉴얼 (18 페이지)
페이지 인쇄SS-UV40
Mounting Control Enclosure & Modules
Mounting brackets are provided on the UV LED module for permanent mounting to a wall, floor or ceiling.
Use proper length screws or bolts to mount the module in the desired location using all four mounting holes
provided on the UV LED module brackets. Note that the brackets can be removed and reoriented for easier
access to the mounting holes.
Mounting brackets are also provided on the Electronics power and control box for permanent mounting to a
wall, floor or ceiling. For wall mounting, the box should be oriented so that the hinge is on the top for proper
access to the control board and for better resistance to water splashing. Use proper length screws or bolts to
mount the box in the desired location using all four mounting holes provided on the outdoor enclosure.
Connecting Power & Power Requirements
CAUTION - The power & control enclosure must be wired to a grounded source of power con-
nected to a GFCI circuit breaker for outdoor installations.
CAUTION - Do not use the SS-UV40 on a dimmable circuit.
The SS-UV40 requires 45 watts of power at 120VAC. The fixture is supplied with bare-end power cable is
ready for wiring to permanently installed junctions or can be wired to plugs for temporary use.
Connecting Data
Connect DMX signal to the fixture using the XLR connections. The DMX signals can be daisy chained from one
enclosure to an adjacent enclosure each with separate connections to a power source.
Access the control board by loosening the three brackets securing the top cover.
Focusing
With the fixture energized and Data connected, point the unit in the direction of the object to be irradiated by
loosening the two screws at either end of the UV LED modules. Adjust the UV LED module to the desired posi-
tion and secure the fixture by tightening the two screw to lock down the UV LED light module.
Installation And Setup
Installation & Users Manual
Page 9