Alto DPA 6000 사용자 설명서 - 페이지 18
{카테고리_이름} Alto DPA 6000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto DPA 6000 20 페이지. 40 bit enhanced
페이지 인쇄
10. TECHNICAL SPECIFICATIONS
MODEL
20Hz [email protected]% THD, Stereo Mode
8 ohms per channel(EIAJ)
4 ohms per channel(EIAJ)
Bridge Mono Mode
8 ohms, 1KHz, 0.1%THD
Distortion (SMPTE-IM)
Frequency Response
Damping Factor, 1 kHz and below
Signal to Noise,20Hz-20KHz
Voltage Gain
Input Sensitivity @ 4 ohms
Input Clipping
Input Impedance
Controls
Indicators (1 per channel)
Connectors, each channel
Cooling
Load Protection
Power Requirements
Dimensions
Net Weight
DPA6000 40 Bit DSP Enhanced Stereo Amplifier
1070W
1500W
3000W
<0.05%
20Hz-20KHz±1dB, -3dB points: 10Hz-60KHz
>400 at 8ohms
110dB A weighted
40x (31dB)
6Vrms
10Vrms (+22dB)
10K ohms unbalanced, 20K ohms balanced
FRONT: AC SWITCH, CH1&2 GAIN KNOBS, DSP controls
REAR: LIMITER, BRIDGE SELECTOR
Power-On: Blue LED
Operation/protection: Dual Color(Green/Red LED)
Limit: Red LED
Clip: Red LED
Input: Active balanced XLR
Parallel Output : XLR
Output: NEUTRIK Speakon and Binding posts
Continuously variable-speed fan, rear-to-front air flow
On/off muting, DC-fault load grounding relay. Internal fault fuses.
220-240(110-120) Vac 50~60Hz
19"(48.3cm) rack mounting, 3.5"(8.9cm) tall(2 rack spaces),
15.9"(40cm) deep (rack mounting to rear support ears)
18.1kg / 20.5kg
17