Alto ELVIS15S 사용자 설명서 - 페이지 6
{카테고리_이름} Alto ELVIS15S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto ELVIS15S 7 페이지. Elvis series speaker cabinet
Alto ELVIS15S에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지)
페이지 인쇄
-. ACTIVE FULL- RANGE Speaker for ELVIS10A / ELVIS12A / ELVIS15A / ELVIS12MA
(1) Bi-polar main power switch.
(2) Input AC power socket with main fuse.
(3) Ground Swicth.
(4) POWER, blue LED, indicate ON status.
(5) SIGN / COMP, signal/compressor, green/red LED
(6) LINE OUT at + 4dB on XLR connector
(7) LINE IN at + 4dB on COMBO connector.
(8) VOLUME main power amplifier control.
(9) LOW / MID / HIGH, EQ tone control at +/- 6dB.
(10) GAIN control for microphone -10/ - 45dB.
(11) MIC IN on balanced XLR, for microphone.
MODEL
SERIAL
AC INPUT: 230V~ 50Hz
Use only with a 250V fuse
(2)
(11)
MIC IN
(10)
MIC GAIN
-10dB
-45dB
HIGH
-6dB
+6dB
(9)
MIDDLE
-6dB
+6dB
LOW
-6dB
+6dB
(8)
VOLUME
-
+4dBu
LINE-IN
(7)
(6)
LINE-OUT
GND
(3)
ON
SIGN
COMP
(5)
POWER
OFF
(4)
(1)
8
2. QUICK START - ACTIVE SPEAKER CABINET
Make all initial connections with all the equipment powered off, and ensure that all the main volume controls are turned completely
down.
-. For Active Full-range Speakers
1). Connect one side of the signal cable at your audio mixer in to Output Left /Right (with Stereo-Jack or XLR) and
the other side of the cable in to the Line Input (COMBO) of your active speaker cabinet (with Stereo-Jack or XLR).
2). Connect the power cord to mains.
3). Turn on your mixer first, then the active speaker cabinets.
4). Turn up the volume control fo the active speaker cabinets.
5). Use PFL function to get the proper input level for the mixer, and adjust the Main Mix Level control to manipulate the
output level.
6). After using, turn off your active speaker cabinets first, then the mixer.
Elvis Active Full-range Speakers
Signal Cable
Power Cord
Main Mix
Tripod
Output
Mount
Mixer
QUICK START
Signal Cable
Power Cord
Left
Right
Main Mix
Output
5
Tripod
Mount