Alto ts115a truesonic 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Alto ts115a truesonic에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto ts115a truesonic 9 페이지.
페이지 인쇄
BOX CONTENTS
•
TRUESONIC speaker
•
Power cable
•
Quickstart Guide
•
Safety Instructions & Warranty Information Booklet
CONNECTION DIAGRAM / INSTALLATION
Microphones*
Speaker
*Note: Microphones, mixer, and cables are not included.
REAR PANEL OVERVIEW
1.
POWER INPUT – Connect the included power cable to
this input and connect the other end of the cable to a
power source.
SWITCH is set to "off" when plugging and unplugging
the cable.
2.
POWER SWITCH – Turns the speaker on/off. Make
sure the VOLUME knob is set to "zero" before turning it
on.
3.
POWER LED – Illuminates when the speaker is on.
4.
VOLUME – Turn this knob to adjust the speaker's
volume.
5.
INPUT – Use a standard 1/4" TRS or XLR cable (not
included) to connect your sound source to this input.
6.
MIX OUT – Use a standard XLR cable (not included) to
connect this jack to the input of another speaker (i.e.,
another TRUESONIC speaker).
7.
SIGNAL LIMIT LED – Illuminates when the audio
signal being sent to the speaker is "clipping" or
distorting. If this light illuminates frequently or steadily,
reduce the volume of your sound source.
8.
CONTOUR – Engage (depress) this switch to
emphasize low and high frequencies by +3 dB. Disengage the switch for flatter response for live
performance or for maximum output.
9.
GROUND SWITCH – Press this switch to reduce hum or noise.
Power
Mixer*
Power
Make sure the speaker's POWER
INSTALLATION:
This speaker should be installed on a
stand on the floor, according to its
maximum weight, or suspended from its
suspension points (M10 x 1.5PH, 30mm
length) (see example image). We do
NOT recommend suspending multiple
speakers in a vertical array.
Speaker
4
5
1
2
Example:
Eyebolt
Dust cover
Suspension
point
7
4
8
3
5
6
9
2