Diverite HunterPac BCD 사용자 설명서 - 페이지 10

{카테고리_이름} Diverite HunterPac BCD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diverite HunterPac BCD 20 페이지.

HunterPac BCD

Attaching the HunterPac to a Cylinder

The HunterPac is easily attached to an aluminum or steel single cylinder using

the two stainless steel cam-bands provided. The cam-bands can be easily

removed for cleaning or transport.

To attach the HunterPac to a cylinder:

1. Thoroughly soak the cam-straps in water and allow them to stretch.

2. Loosen the cam-straps to fit the size of the cylinder.

3. Slide the cam-straps over the cylinder.

4. Hook the tank-height adjustment strap over the cylinder valve and position

around the neck of the cylinder.

See "Adjusting the Tank Height Adjustment Strap" for more information.

5. Position the HunterPac to the desired height on the cylinder.

Note: When the tank height adjustment strap is adjusted correctly, you

should be able to reach back and turn on/off your cylinder's valve.

6. Tighten the cam-straps until they snap tightly around the cylinder.

7. Pick up the unit by the harness shoulder straps and shake it up and down.

Make sure that the tank is fastened securely and that the band is tight

enough to prevent it from coming undone accidentally. If the cam-strap is

not tight enough, tighten it and perform the shake test again.

WARNING: Before each use, check the HunterPac cam-bands, straps, and the

waist strap for wear. Have an authorized repair facility replace worn or

damaged items before use. Failure to replace worn or damaged tank buckles

and bands could lead to loss of cylinders or of the

HunterPac assembly itself. This could lead to

serious personal injury or death.

The tank-height adjustment strap hooks over the

cylinder valve and is positioned at the neck of the

cylinder. It is used to maintain a consistent height

position for the HunterPac each time you attach it to a cylinder. The strap can