Alto DX 865 사용 설명서 - 페이지 9

{카테고리_이름} Alto DX 865에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto DX 865 11 페이지. Alto-shaam inc. vacuum cleaner user manual

페이지 인쇄
Alto DX 865 사용 설명서
DX 845 W / DX 865 / DX 985 / TitanEnergy / TitanEnergy X
GB

TROUBLESHOOTING

FAULT
‡
Display
does not light up,
machine does not start
‡
Display
flashes rapidly (5x per
second), motor has cut out and will
not start again
‡
Display
is lit continuously
‡
Display
is lit continuously
‡
Display
flashes slowly (1x per
second)
‡
Display
flashes rapidly (5x per
second), burner will not start again
‡
Machine stops and starts intermit-
tently with the trigger gun open
‡
Machine stops and starts intermit-
tently with the trigger gun closed
‡
Pressure too low
‡
Cleaning agent is not drawn in
12
Before working on the machi-
ne, remove the mains lead
plug and depressurise the
machine.
CAUSE
>
Fault in the mains cable
>
Motor overheated
>
Anti-Stone concentrate container
empty
>
Fuel tank empty
>
Contamination or water in fuel
>
Burner sooted
>
Inadequate water inlet
>
Cleaning agent tank empty
>
Pressure and volume controller or
VarioPress trigger gun set too low
>
Flame sensor sooted
>
Fault in ignition or fuel system
>
High-pressure nozzle soiled
>
Machine scaled
>
Trigger gun leaking
>
High-pressure hose, high-pressure
screw fitting or pipework leaking
>
Cleaning agent tank empty
>
High-pressure nozzle worn
>
Pressure and volume controller or
VarioPress trigger gun set too low
>
Filter in water inlet clogged
>
High-pressure pump drawing in air
>
Suction or pressure valve of high-
pressure pump soiled or defective
>
Cleaning agent tank empty
>
Sludge in cleaning agent tank
>
Suction valve at cleaning agent
inlet soiled
REMEDY
ð
Have electrical connection checked
ð
Clean or replace clogged high-
pressure nozzle
ð
Set the VarioPress control knob
on the trigger gun to a higher
pressure
ð
Possible phase failure; have
electrical connection checked
ð
Top up anti-scale concentrate
container
ð
Top up fuel tank
ð
Clean fuel tank and pipework
ð
Have burner setting checked
ð
Use water hose with at least 1/2"
diameter, clean filter in water inlet
ð
Top up cleaning agent tank
ð
Set pressure and volume controller
or VarioPress control knob on the
trigger gun to a higher pressure
ð
Remove and clean
ð
Call service technician
ð
Clean or replace high-pressure
nozzle
ð
Descale according to the instruc-
tions
ð
Inspect the trigger gun
ð
Retighten screw fittings, replace
high-pressure hose or pipework
ð
Top up cleaning agent tank
ð
Replace high-pressure nozzle
ð
Set pressure and volume controller
or VarioPress control knob on the
trigger gun to a higher pressure
ð
Clean filter
ð
Repair leaks
ð
Clean or replace valves
ð
Top up cleaning agent tank
ð
Clean cleaning agent tank
ð
Remove suction valve and clean or
replace
1)
Option / model variants