diversey CO350.5X 매뉴얼 - 페이지 6

{카테고리_이름} diversey CO350.5X에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. diversey CO350.5X 11 페이지.

페이지 인쇄

• Remount the brush holder and lock it.

Attach squeegee

• Place the squeegee on the floor in front of the

machine.

• Incline the machine to the rear and run over the

squeegee.

• Set the machine on the floor again.

• Place the locking nut in the slot provided.

• Turn the locking nut through 90°.

Filling water

Caution:

Maximum permissible water temperature 60 °C/140 °F.

• Switch the machine off.

• Remove the rubber cap from the solution tank.

• Fill the solution tank with water up to the

maximum filling level.

10L

• Replace the rubber cap on the solution tank.

Dosage:

Caution:

Wear protective gloves, goggles and the corresponding

(protective) work clothing when handling chemical products!

Only use chemical products recommended for the scrubber dryer by the

manufacturer.

Caution:

The use of other products (e.g. products containing chlorine)

could damage or destroy the machine.

Dosing examples (the concentration is product-dependent):

Instructions on the product's

packaging

0.25%

25ml to 10l water

Tank capacity

Product amount

per tank filling

10l

25ml = 0.25l

Instructions on the product's

packaging

0.5%

50ml to 10l water

• Add the product measured with the dosing cup to the water in the solution

tank.

Dosing variants:

• The TASKI J-Flex dosing system or the QFM dosing station can also be

used for simplified and quicker dosing.

Please contact your TASKI partner for further information about these

systems.

Start of operation

Caution:

Always wear non-slip shoes and appropriate work clothing while

working with this machine!

• Bring the machine into the working position by

swivelling the parking support up.

• Pull the height adjustment lever on the machine

handle and slowly lower the central steel pillar

into a comfortable working position, making

sure your arms are almost straight.

• Release the height adjustment lever, and the central steel pillar will then lock

into place.

Manual setting of the functions when using for the first time

• Switch the machine on. To do this, hold down

the ON/OFF button (main switch) for 3 seconds.

• The cleaning solution button is automatically

pre-selected.

(See page 47: When switching on again)

• Press the suction unit button.

The indicators light up briefly.

• Adjust the water quantity with the volume

regulation.

1. low: for smooth surfaces, raised

2. medium: for smooth surfaces, free areas

3. high level:

soiled areas

• Pull the operating lever.

By doing this the tool is activated.

Tank capacity

Product amount

per tank filling

10l

50ml = 0.5l

indirect cleaning and heavily