Alto PRO X-TRA 사용 설명서 - 페이지 5

{카테고리_이름} Alto PRO X-TRA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto PRO X-TRA 11 페이지. High pressure washer
Alto PRO X-TRA에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지)

페이지 인쇄

Operating Instructions

2.4 Operation

1. Always hold the spray lance ﬁ rmly with

both hands! The spray lance is affected

by a lon gi tu di nal thrust of up to 26.5 Nm

when the high pressure washer is operated.

2. Point the nozzle at the ground.

3. Activate the trigger of the spray handle (6a).

4. Always adjust the distance and thus the pres-

sure of the nozzle to the sur face which is to be

cleaned. NOTE: The pressure can be reg u lat ed

on the TORNADO

NOTE: Do not cover the machine during operation. If

the machine is left or not used for 5 minutes, it must

be switched off on the start/stop switch (pos. O).

Operation with detergents

Application of detergents is NOT possible if an

extension hose is applied.

Fill the tank with a detergent.

2. Mount the TORNADO

pressure (turn to the right).

3. Adjust the dosing regulator to the re quired vol-

ume of detergent.

4. Apply the detergent from below and up wards.

5. Let the detergent act for the time stated on the

packing of the detergent and ﬂ ush with pure water.

2.5 Suction mode

The machine can take in water from a rain water

butt as an example. The water inlet hose must not

be too long, approx. 5 m.

1. Make sure that the water butt is not placed on a

lower level than the ma chine.

2. Attach the water inlet hose to the ma chine and

place the other end of it in the water butt.

3. Start the machine.

4. Detach the spray lance and activate the trigger of

the spray lance. Keep the trig ger activated until

water has come out for approx. 15 sec onds.

5. Remount the spray lance and the ma chine is

ready for operation.

NOTE: The internal ﬁ lter of the machine is not

intended for the ﬁ ltration of large quan ti ties of im-

purities. If the water contains leaves, sand or the

like, an external suction ﬁ lter should be mount ed.

For further in for ma tion, please contact your near est

ALTO dis trib u tor.

2.6 End of operation

1. Stop the machine by turning the start/stop switch

(2) to pos. O.

2. Disconnect the plug from the sock et.

3. Shut off the water supply and ac ti vate the trigger

(6a) to relieve the machine of pres sure.

Concerning storage, please refer to section 5.0.

nozzle.

nozzle and adjust it to low

3.0 Accessories

Equipment

Only use original accessories.

Nozzles

Tornado

Powerspeed

Extension hose

Brushes

Tube cleaner

Water-sand-

blasting equipment Sand avail a ble from do-it-

Patio Clean er

Garden brush

Rim brush

Detergents

Only use original accessories.

Stone & Wood

Cleaner

Plastic Cleaner

Attached with the bayonet

coupling system. Stored on

the ma chine.

(8)

Universal adjustable nozzle.

Turn to the left:

high pres sure.

Turn to the right:

low pres sure.

(9)

Nozzle with rotating jet for

stubborn dirt on hard sur-

fac es.

7 m extension hose in-

creas ing the working range.

For cars and

other surfaces.

Available in more

shapes.

15 m long tube clean er for

the clean ing of tubes and

drains.

For removal of paint and rust.

yourself shops.

Equipment for quick

and regular clean ing

of horizontal (tiles

etc.) and vertical

sur fac es.

Rotating brush for cleaning of

wooden surfaces.

Rotating brush for cleaning of

wheel rims.

For ﬂ agstones, brick- and

woodwork.

Suitable for moss and algae.

For plastic and syn thet ic

ma te ri als such as garden

fur ni ture.