DIVERSIFIED DT-60SA 조립 지침 매뉴얼 - 페이지 11
{카테고리_이름} DIVERSIFIED DT-60SA에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DIVERSIFIED DT-60SA 12 페이지. Drawing table system
페이지 인쇄
IN HOUSE ASSEMBLY TEMPLATE
SEE DETAIL - A
FOR CPU
BRACKET
INSTALLATION
NOTE:
1.
K:\AutoCAD\Assembly Instructions\DT-30A, DT-60SA, & CDTC-70.dwg,
1/25/2022 10:11:15 AM, DWG To PDF.pc3
A
CREATED ASSEMBLY INSTRUCTIONS
1/15/15
EMR
REV.
DESCRIPTION
DESCRIPTION
DATE
DATE
NAME
NAME
REVISION LEVEL
STEP 9:
•
SCREW BACK PLATE OF CPU BRACKET ONTO CPU SUPPORT WITH PROPER HARDWARE.
•
BACK PLATE WILL HAVE SCREW HOLES TO ATTACH TO CPU SUPPORTS .
•
TAKE FRONT PLATE OF CPU BRACKET AND ATTACH TO BACK PLATE.
•
FRONT PLATE WILL HAVE SLOT HOLES FOR ADJUSTING TO CORRECT WIDTH.
•
USING THE (2) KNOBS, ADJUST PLATES TO CORRECT SIZE AND SCREW TWO PLATES TOGETHER.
•
MAKE SURE KNOBS ARE ON TIGHT AND SECURE.
•
PLACE RUBBER BUMPERS IN DESIRED LOCATION - (4) ON EACH SIDE AND BOTTOM.
3RD -
RUBBER
BUMPER - TYPICAL
FRONT PLATE
1ST
KNOB - TYPICAL
DATE
ALL DIMENSIONS ARE IN INCHES UNLESS
DWN
1/15/15
EMR
NOTED OTHERWISE
DWN:
BY:
DECIMALS: .X = ± .030
APR
DATE
.XX = ± .020
BY:
APR:
.XXX = ± .010
APR
DATE
ANGLES: = ± 1°0'
CABINET SQUARENESS = ± .0625
BY:
APR:
CONFIDENTIAL:
ALL DESIGN RIGHTS RESERVED
THE INFORMATION, DATA, DESIGN, AND DRAWINGS EMBODIED
IN THIS DOCUMENT AND ALL REPRODUCTIONS THEREOF ARE
THE EXCLUSIVE PROPERTY OF DIVERSIFIED WOODCRAFTS, INC.
THESE DOCUMENTS ARE SUPPLIED WITH THE UNDERSTANDING
THAT THEY WILL NOT BE DISCLOSED TO THIRD PARTIES WITHOUT
-
WRITTEN CONSENT OF DIVERSIFIED WOODCRAFTS, INC. ANY
ECN NO.
REPRODUCTION IN PART OR WHOLE WITHOUT WRITTEN
CONSENT IS SUBJECT TO LEGAL ACTION.
DETAIL - A
CLOSE UP OF CPU BRACKET
2ND
CPU SUPPORT
TITLE:
DRAWING TABLE SYSTEM - PLAIN
ASSEMBLY INSTRUCTIONS
SCALE:
DRAWING NUMBER:
DT-30A, 60SA, & CDTC-70
NTS
BACK PLATE
SHEET:
REVISION:
11 OF 12
REV A