Alto LYNX-MIX62FX 사용자 설명서 - 페이지 13

{카테고리_이름} Alto LYNX-MIX62FX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto LYNX-MIX62FX 20 페이지.

5. INSTALLATION AND CONNECTION

Ok, you have got to this point and you are now in the position to successfully

operate your

L YNX-MIX62(FX)

following section to be the real master of your own mix. Not paying attention

enough to the input signal level, to the routing of the signal and the assignment of

the signal will result in unwanted distortion, a corrupted signal or no sound at all.

So you should follow this procedure for every single channel:

1. Turn down all Input and Output Gain Controls.

2. Connect phantom powered microphones before switching on the +48 Volt

phantom power switch.

3. Set the output level of your

no more than 75%.

4. Now, set the CONTROL ROOM/PHONE level at no more than 50%.

5. Position HI, MID and LOW EQ controls on middle position.

6. Position panoramic (PAN/BAL) control on center position.

7. With a pair of headphones or studio monitor speakers connected apply a

Line Level input signal so that the PEAK LED does not light up.

8. While speaking into the microphone (or playing the instrument), adjust the

channel level control so that the PEAK LED will blink occasionally, in this way

You will maintain good headroom and ideal dynamic range.

9. Now repeat the same sequence for all input channels. The Main LED Meter

could move up into the red section. In this case, you can adjust the overall

output level through the MAIN MIX control.

Audio Connections

You can connect unbalanced equipment to balanced inputs and outputs. Simply

follow these schematics.

Strain Clamp

. However, we advise you to read carefully the

L YNX-MIX62(FX)

Ring

Ring=Right Signal

Sleeve

Tip

Sleeve=Ground/Screen

Use for Headphone, Stereo Return

1/4" Stereo (TRS) Jack Plug

Sleeve Tip

Sleeve=Ground/Screen

Use for Mono Line In, Mono 1/4"Jack Plugs

1/4" Mono (TS) Jack Plug

or the connected power amplifier at

Tip=Left Signal

Tip=Signal