Alto Professional Transport 12 사용자 설명서 - 페이지 5

{카테고리_이름} Alto Professional Transport 12에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto Professional Transport 12 15 페이지.

페이지 인쇄

11. Wireless Mic Display: This display shows the current reception settings of the wireless

module. See

Operation > Using the Wireless Microphone

12. Up/Down: Use these buttons to move to the next-highest or next-lowest channel of the

wireless module. See

13. Set: Press this button to confirm the current setting of the wireless receiver. See

Operation > Using the Wireless Microphone

14. Wireless Mic Volume: Turn this knob to adjust the volume of the wireless microphone

(included). See

15. RCA Inputs: Use a stereo RCA cable (not included) to connect an audio source to these

inputs. Use the USB/Aux Volume knob to adjust the level.

16. USB/Aux Volume: Turn this knob to adjust the volume of the RCA inputs and USB player.

This knob works in conjunction with the Vol –/+ buttons on the USB player.

17. USB Player Display: This display shows the current operation of the USB player. See

Operation > Using the USB Player

18. USB Port: Connect a USB drive with playable music files to this USB port. This USB port

is for file playback only, not for charging other devices. See

Player

to learn more.

19. Previous/Next (

are currently in the middle of a track, press Previous (

track. See

Operation > Using the USB Player

20. Vol –/+: Use these buttons to lower or raise the volume of the USB player. These buttons

work in conjunction with the USB/Aux Volume knob. See

Player

to learn more.

21. Play/Pause (

Using the USB Player

22. Power/Stop (

USB player. During playback, press this button to stop playback and return to the

beginning of the track. See

23. Repeat (

): Press this button to cycle through the playback modes:

•

Normal (no indication): Tracks will play in their normal order and then stop.

•

Repeat 1 (REP 1): The current track will repeat.

•

Repeat All (REP ALL): The entire sequence of tracks will repeat.

•

Random (REP): The entire sequence of tracks will play in a random order.

See

Operation > Using the USB Player

24. Line Out (1/4"/6.35 mm): Use a standard 1/4" (6.35 mm) cable (not included) to connect this

output to the input of another loudspeaker, mixer, audio interface, etc. The signal sent from

this output is a summed mono signal of all audio sources and the USB player, post-EQ.

25. EQ (Treble): Turn this knob to increase or decrease the high (treble) frequencies.

26. EQ (Bass): Turn this knob to increase or decrease the low (bass) frequencies.

Operation > Using the Wireless Microphone

): Use these buttons to move to the previous or next track. If you

): Press this button to start/resume or pause playback. See

to learn more.

): Press and hold this button for 3 seconds to activate or deactivate the

Operation > Using the USB Player

to learn more.

Operation > Using the USB

) to return to the beginning of the

Operation > Using the USB

to learn more.

Operation >