Balmar ARS-5 설치 및 운영 매뉴얼 - 페이지 10

{카테고리_이름} Balmar ARS-5에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Balmar ARS-5 16 페이지. Multi-stage voltage regulator
Balmar ARS-5에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Programming For Short Or Long Display Mode

You can choose the amount of information displayed on the regulator. The information displayed on the short or long dis-

play is detailed on Page 7 of the manual. To adjust the regulator for short or long display:

TOUCH / HOLD when entry into the short/long display selector is indicated by dSP on the regulator's LED.

The regulator display will indicate codes Sd (for short display) or Ld (for long display).

RELEASE when the display indicates your desired display mode. The display will cycle to dSP. You can re-activate to

change your selection, or wait until the regulator cycles to the next programming mode.

INDICATES ENTRY INTO SHORT

OR LONG DISPLAY MODE

Programming For Alternator Failure Advisory Mode (BDL)

The regulator provides a ground signal on the dash lamp terminal when the following conditions occur: low battery volt-

age (<12.7V), high battery voltage (>15.5V), high battery temperature (>52˚C), or high alternator temperature (105˚C). In

addition, the user has the option to send the dash lamp to ground in the event that the stator output drops to zero volts.

The Regulator's Default bdL setting is ON. Monitoring stator output is an optional function which can be turned on or off

in the basic programming mode. The regulator's default setting for the bdL mode is ON, meaning that the stator output is

being monitored. This function can be used in conjunction with a relay to control a charge indicator lamp.

To enable or disable the stator monitoring function, activate and hold when the bdL mode is indicated. Release when the

desired setting is shown. NOTE: Stator wire must be connected to the regulator's Stator-In terminal to use this function.

bdL

INDICATES ENTRY INTO ALTERNA-

TOR FAILURE ADVISORY MODE

INDICATES END OF BASIC PROGRAMMING MODE

notes:

INDICATES SHORT

DISPLAY MODE

OFF

STATOR OUTPUT

MONITORING OFF

- 10 -

INDICATES LONG

DISPLAY MODE

STATOR OUTPUT

MONITORING ON