Balt 27530 조립 지침 - 페이지 4

{카테고리_이름} Balt 27530에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Balt 27530 5 페이지. Adjustable ht lcd cart with 2 pull-out shelves & locking cabinet

페이지 인쇄

4.)

Attach Left and Right Support Tubes (P-4 & P-5)

to Top Shelf (P-2) using 2 screws (A4) and 2

Washers (C1) as shown in illustration # 3.

5.)

Attach Cord Winder (P-8) and Electrical

Strip (P-9) to Top Shelf (P-2), or Base

Cabinet (P-1) using 2 screws (A2) and 2

Hex Nuts M5 w/Flange (B2).

6.)

Tighten all screws using

Phillip's head screwdriver and

Wrench (Not Provided).

Illustration # 4

P-7

P-5

The product you have purchased is guaranteed against material and workmanship defects. This guarantee

extends 1 year from date of purchase. Should this product fail to function satisfactorily under normal use due to

defect or imperfection, the defective part or product will be replaced. Damage caused by common carriers during

shipment is not included in this guarantee.

This guarantee sets forth all applicable guarantees and remedies. No other warranty, expressed or

implied shall apply. Failure to follow instructions found in Important Information Section of Owner Sheet

shall void the guarantee. Consequential or incidental damages and or costs are not refundable.

P-8

P-9

P-6

P-4

P-6

Important

P-5

P-4

P-7

7.)

P-2

8.)

Illustration # 3

P-2

Attach 2 LCD Brackets

(P-6) to Left and Right

Support Tubes (P-4 & P-5)

at desired height using 4

screws (A5) as shown in

illustration # 4.

Attach 2 Verticle Adj

Straps (P-7) to the 2 LCD

Brackets (P-6) at desired

width using 4 screws (A3)

and 4 Hex Nuts (B3) as

shown in illustration # 4.