3DR IRIS PIXHAWK 장착, 전기 연결, 조정 - 페이지 4

{카테고리_이름} 3DR IRIS PIXHAWK에 대한 장착, 전기 연결, 조정을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DR IRIS PIXHAWK 6 페이지. Improvement update

2 Attach foam to Pixhawk.

Separate the four foam squares, and

remove the adhesive backing from

one side. Place one square onto each

corner of the bottom of Pixhawk

without disconnecting any of the

cables.

3 Align guide to plate.

Place the guide over the back-left

corner of the plate as shown. It may

be helpful to tape the guide in place.

4 Check position of splitter.

Align the top-right corner of Pixhawk

with the guide. If the I

C splitter is

touching Pixhawk, complete this step

to adjust its position.

Use a flat-head screwdriver or similar

tool to wedge the splitter and

adhesive gently away from the plate.

To avoid damaging the splitter, do not

use too much force or put pressure

on the connectors.

Move the splitter a few millimeters

away from Pixhawk so that it won't

touch the board in its new position.

The splitter may overlap slightly onto

the cutout in the plate as long as it

can stick securely in place.

Be very careful when completing these steps! The adhesive on the foam will

only stick once, so make sure to place the pieces carefully the first time.

example of foam attached

to the bottom of Pixhawk

Pixhawk situated in the correct position,

aligned with the guide, with the proper

clearance for the splitter

C splitter

If the splitter touches Pixhawk in its new

position, use a tool to adjust the position of

the splitter so that it has a few millimeters

of clearance between the two components

as shown.