Baltech VP-3410 운영 매뉴얼 - 페이지 11

{카테고리_이름} Baltech VP-3410에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baltech VP-3410 16 페이지. Vibration meter
Baltech VP-3410에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지)

페이지 인쇄

4.3.3. Execution of measurements

To carry out the following measurements:

1. Press and withhold the measurement button during

several seconds, after that the vibration meter is ready for

measurement;

2. Install a sensor on measurement point. Press

measurement button and withhold it. Upon that on the

screen it will appear the result of measurement.

3. Release the measurement button. The measured value

will be on the screen, and you can read and record it.

4. Press the measurement button for further measurements.

ATTENTION

The sensor must be reliably connected with measured object,

otherwise the results of measurement can be inaccurate.

MAINTENANCE SUPPORT OF VIBRATION

METER

It is necessary to keep vibration meter VP-3410 clean, not to

allow severe contamination. If there any contaminations on the

electronic unit, then one should wipe it with wet nap.

5.1. Replacement of batteries

If while operation with the fixture it will appear a message

«BAT» and it means that

necessary to replace battery.

For replacement of battery (Pic. 5-1):

Step 1

Step 2

Step 3

battery supply is very low, it is

Open the battery pack;

Insert the battery type D in accordance with

markings of battery polarity;

Close the battery pack.