3DS MAX1024-U 사용자 설명서 - 페이지 7

{카테고리_이름} 3DS MAX1024-U에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DS MAX1024-U 11 페이지. Solar controller

Solar charge controller MAX series User Manual

5.3.3 Overcharge protection voltage (lithium battery)/boost voltage (other battery types)

1.When the battery type is lithium battery,you can set the lithium battery overcharge

protection voltage on the current screen.Setting range:12/24V:10.1~32.0V(default 14.4V)

Note: The controller automatically calculates the overcharge recovery voltage

according to the overcharge protection voltage, and the overcharge recovery

voltage is ≈(0.97*overcharge protection voltage).

2. When the battery type is AGM/GEL/LIQ , you can set the boost voltage on the current

screen.The equalization voltage is boost voltage +0.3V(12V system)/+0.6V(24V system).

The float voltage is boost voltage -0.8V/1.6V.

Note: The GEL battery is not have equalization.

5.3.4 Low voltage protection

5.3.5 Load mode

1.When the battery type is lithium battery,you can set the lithium battery low voltage

protection voltage on the current screen. Setting range：9.0~30.0V(default 10.6V)

Note: The controller automatically calculates the low-voltage recovery voltage

according to the set low-voltage protection voltage. The low-voltage recovery

voltage is ≈1.11* low-voltage protection voltage.

2. When the battery type is GEL/LIQ/AGM,

Setting range：10.8~11.8.V/21.6~23.6V(default 11.2/22.4V)

Note: The default low-voltage recovery voltage of the controller is 0.8V/1.6V

higher than the low-voltage protection voltage. To reduce the low-voltage

recovery voltage, lower the low-voltage protection voltage first.

Universa type controller, 24H output (default).

When the controller is set to 24H output mode, there is always an output at the

load end

regardless of the charging or discharging state (except the protection state).

Note: The test function is not valid in this state

Dusk to Dawn Mode (D2D)

Lighting time at night (time 1~12 hours); 01 to 12 corresponds to 1 to 12 hours

Light control priority, when the PV voltage >

down

the load.

Lighting time in the day (time 1~12 hours); 01 to 12 corresponds to 1 to 12 hours

The load is turned off at night, and the load is turned off after the lighting period

is performed during the day

Page 6 of 10 pages

Optically controlled spot

, then shut