Baltech ACCESS200 설치 매뉴얼
{카테고리_이름} Baltech ACCESS200에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baltech ACCESS200 2 페이지.
Baltech ACCESS200에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지)
페이지 인쇄ACCESS200 installation guide for SNET
1. Install readers
Fix the base part to a single gang box or directly to the mounting surface.
Use 3 mm diameter countersunk head screws. Heads must not stand out
more than 1 mm from the base surface.
When using stranded wires, make sure there are no wires outside the
•
cages of the pluggable cage clamp.
To avoid rain interference, mount outdoor keypad readers upright or
•
at a protected spot. Otherwise, ensure large water drops are wiped off
if readers are malfunctioning.
Pigtail cable connection / Molex Pico-SPOX (outdoor/potted
versions) stranded, AWG28, power Red&Black AWG 24
Color
Connector pin #
White/Orange
Orange
White/Green
Green
Red/White
Black/White
Red
Black
White/Blue
Blue
White/Brown
Brown
2. Optional: Set bus address
This step is only needed if you want to assign each reader an individual address: Present a
BALTECH AdrCard to the reader, and wait for the signal indicating the desired address.
Learn more:
docs.baltech.de/bus-address
Note: The documentation refers to the OSDP protocol, but the steps for SNET
are the same as both protocols are based on RS-485.
BALTECH AG
Phone:
Lilienthalstrasse 27
Fax:
85399 Hallbergmoos
Mail:
Germany
Website:
Signal/funct.
1
WIE_D0/RS485A
2
WIE_D1/RS485B
3
LEDGN
4
LEDRD
5
USB Data -
6
USB Data +
7
+VIN
8
GND
9
GND
10
REL_WC
11
REL_NO
12
REL_NC
+49 (811) 99 88 1-0
+49 (811) 99 88 1-11
www.baltech.de
Connector and pins
(reader rear view)
J8 Pluggable cage clamp
(indoor versions)
Pin #
Signal/funct.
J8-1
GND
J8-2
+Vin
J8-3
WIE_D0/RS485A
J8-4
WIE_D1/RS485B
J8-5
LEDGN
J8-6
LEDRD
J8-7
REL_WC
J8-8
REL_NO
J8-9
REL_NC
v1.1
p 1/2