Camfil FB Series 설치, 운영 및 유지보수 매뉴얼 - 페이지 7

{카테고리_이름} Camfil FB Series에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camfil FB Series 20 페이지. Fluid seal bag-in/bag-out

5. To gain access to the inside of the filtration housing, remove the housing access doorknobs by turning

counter-clockwise (for housings equipped with swivel latches: do not remove doorknobs; loosen and swivel

door bolt out from door corner retainer). Pull the access door straight towards you to remove.

6. To install prefilter(s) (if required for the application), push the prefilter inside the housing using the slide

track. Make sure to install prefilters with the pleats in the vertical position.

7. To install primary filter(s)/adsorber(s), release the locking mechanism handle from the handle latch. Slowly

open the locking mechanism by pulling the handle fully open. Load the filter(s)/adsorber(s) into the housing

with the fluid seal channel towards the housing knife-edge (opposite the locking mechanism). Make sure

the filter/adsorber is correctly orientated when placing inside of the filtration housing. The filter clips should

be positioned on the top and bottom of the filter (see pictures). The filter shall be installed with the pleats,

or separators in the vertical position. Install adsorbers with the carbon beds in the horizontal position.

Push the filter(s)/adsorber(s) to the back of the filtration housing until it stops. For filtration housings that

contain more than one filter/adsorber, it may be necessary to push one filter as far inside the housing as

possible. Next, install the second filter to help push the first filter to the back of the housing. When all the

filter(s)/adsorber(s) are installed correctly in a multi-wide housing, the last filter/adsorber edge should be

aligned with the sealing surface edge.

Correct filter installa-

tion, with locking tray

angle between clip and

filter frame

Incorrect filter installa-

tion, with locking tray

angle outside clip and

filter frame