ClearChoice Premium Series 사용 설명서 및 설치 설명서 - 페이지 4
{카테고리_이름} ClearChoice Premium Series에 대한 사용 설명서 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearChoice Premium Series 7 페이지. Under sink drinking water system
페이지 인쇄• drill a pilot hole with a 1/8" or similar bit
• drill hole for the faucet with 1/2" bit
For Ceramic Tile Countertop:
• counter must be at least 5/8" thick
• follow steps for Porcelain sink
Step 7. – Install the Faucet
Slide the 1 1/4" rubber washer, chrome faceplate and
1 7/8" rubber gasket on to the threaded faucet stud.
These parts will sit above the sink/countertop.
Place the threaded faucet stud through the hole in the
sink / countertop and position the faucet, handle and
faceplate with the gasket.
From the underside of the counter, slide the black plastic
washer, the lock washer, and faucet nut onto the
threaded faucet stud.
Tighten the faucet nut while holding the faucet in position
with a padded crescent wrench. Do not over-tighten. It only needs to be hand tight.
Once the faucet is installed, place a couple of wraps of Teflon tape on the bottom of the threaded
section and attach the plastic quick connect faucet adapter fitting.
See diagram for details.
Step 8. – Install the Saddle Valve for Feed Water Supply
Caution: Do not connect the saddle valve to the hot water pipe. This system is designed to be used
with a cold water supply only (maximum 100F / 37c).
The saddle valve may be installed on copper tube, or iron, brass, steel, or CPVC pipe as follows:
Installing on soft copper tubing:
1. Turn off the water supply and drain the line by opening a nearby faucet until the water stops
running.
2. Turn the saddle valve handle counter clockwise (outward) until the lance does not protrude
from the black gasket.
3. Position the saddle valve around the tubing as shown in the diagram and insert the back
plate. Note that the back plate is reversible depending on whether you have 3/8" or 5/8"
diameter tubing. Match the back plate so that it fits your pipe diameter as close as possible.
4. While holding the saddle valve in place, tighten the brass screw to secure the valve firmly
against the pipe.