Camille Bauer SINEAX U553 사용 설명서 - 페이지 11

{카테고리_이름} Camille Bauer SINEAX U553에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Camille Bauer SINEAX U553 12 페이지. Transducer for ac voltage
Camille Bauer SINEAX U553에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

Symbol

Meaning

Double insulation, device of protection class 2

Test voltage of insulation according to IEC60051:

3,7

AC 3.7 kV

Class icon to the EN60688:

0,5

error limit 0.5% of span

CE conformity mark. The device fulﬁ lls the

requirements of the applicable EC directives.

CSA approved for USA and Canada

ﬁ le-nr. 204767

Germanischer Lloyd

Type approval certiﬁ cate: 12 259-98 HH

Caution!

General hazard point.

Read the operating instructions.

General symbol: Input

General symbol: Output

General symbol: Power supply

Measurement category CAT III for current and

CAT III

voltage inputs

6. Adjustable measuring range

Reliably isolate the measuring input from

dangerous voltages.

Setting:

Admissible alteration of full scale

output, variable sensitivity, adjust-

able with potentiometer P200.

Setting range:

0.85 - 1.15 · U

100%

P201

P200

10 11 12 13

–

0,5

4-20mA

Fig. 6. Locations of the potentiometers P201 and P200.

(± 15%)

Input

0.85

1.15

7. Commissioning and maintenance

Switch on the power supply and the measuring input. It is

possible during the operation to disconnect the output line

and to connect a check instrument, e.g. for a functional test.

No maintenance is required.

8. Releasing the transducer

Release the transducer from a top-hat rail as shown in

Fig.7.

Fig. 7

9. Instruments admissions

Germanischer Lloyd

Type approval certiﬁ cate: 12 259-98 HH

CSA approved for USA and Canada

ﬁ le-nr. 204767

FCC Compliance and Canadian DOC Statement

This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to both part

15 of the FCC Rules and the radio interference regulations

of the Canadian Department of Communications: These

limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses

and can radiate radio frequency energy and, if not instal-

led and used in accordance with the instruction manual,

may cause harmful interference to radio communications.

Operation of this equipment in a residential area is like to

cause harmful interference in which case the user will be

required to correct the interference at his own expense.

10. Dimensional drawing

112.5

114.1

Fig. 8. Housing type P13/70 clipped onto a top-hat rail

(35 ×15 mm or 35×7.5 mm, acc. to EN 50 022).

12 13

4 5