3DUpFitters CR-10 Smart Enclosure Kit 설치 매뉴얼 - 페이지 3

{카테고리_이름} 3DUpFitters CR-10 Smart Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters CR-10 Smart Enclosure Kit 19 페이지.

You Really Do Want to Read the Directions

Hey, we get it. You just got your new enclosure kit and want to start using it as fast as possible.

How hard can assembling a few plastic panels possibly be? It's not really that hard, assuming

you're following the directions, but try to use brute force and you'll end up working your way

through your vocabulary of swear words. While the acrylic pieces in the kit are strong and

diﬃcult to harm accidentally, they are still plastic and will break if bent far enough. The ghosts

of the broken panels that have gone before you have become much stronger than you could

ever imagine, and are whispering into your ear, "just be a little careful".

Before you Start

Is This Manual for Your Kit?

This installation manual covers the enclosure design for the Creality CR-10 Smart 3D printer. If

you have a diﬀerent 3D printer you can ﬁnd the installation manual at the bottom of any

product page on our website.

Is your Printer Customized?

If your printer is stock then no customization is needed. If you have customized the printer,

you should examine any modiﬁcations to make sure they don't block the panels. If part of one

of the panels is blocked, you can use a laser or drill to customize one or more panels. This

should be done before removing the plastic or paper covers on the acrylic panels.

Cutting acrylic requires great care as the plastic is prone to crack if mishandled.

Preparing the Printer 

Remove any ﬁlament from the hot end (will require heating the hot end) and remove the

ﬁlament spool from the spool holder.

Turn the printer oﬀ and unplug the power cable from the printer's power supply.