3DUpFitters CR-10 Smart Enclosure Kit 설치 매뉴얼 - 페이지 9

{카테고리_이름} 3DUpFitters CR-10 Smart Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters CR-10 Smart Enclosure Kit 19 페이지.

Attach the door knob by ﬁrst inserting the square M4 nut into

the slot. Use a 16mm cap head screw to attach the door.

Now that the latches are mounted it is time to connect the

strike plates. Each plate comes with a squishy adhesive

covering the same size of the plate. Carefully attach the

adhesive side to the acrylic at the location of each latch.

Then, adjust the width of the metal strike plate so that it is

held on by the pressure of the two sides of the plate. The

adhesive covering will keep the metal strike plate from

scratching the acrylic.

Pro Tip!

You can more easily adjust the front door so that it swings freely and ﬁts perfectly by

ﬁrst placing the front on its side so that the hinges are at the top. Next, loosen the

hinge screws and use the strike plates to hold the door in place. Try to position the

inside door so that the gap is equal on all sides, and then tighten the hinge screws.

3. Attach Left Side

Attach the left side to the front forming an L-shape that

will stand up on its own, then attach one L and one R

connector at the back. The CR-10 Smart design adds a

side door for easy access to the extruder, the parts for

which are shipped in a separa.

The latch mounts are smaller than the front, although

the magnetic latch attaches in the same way with wood

screws. The parts for the side door will be in a separate

packet.