3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 설치 매뉴얼 - 페이지 11

{카테고리_이름} 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 16 페이지.
3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대해서도 마찬가지입니다: 설치 매뉴얼 (15 페이지)

페이지 인쇄

as the displays are diﬀerent.

CR-6

The CR-6 display mount looks like the piece to the right,

and attaches to the two screws in the corner connector on

the right-side panel. The cable ﬁts through the slot, while

you can mount the display to the front using 14mm M4

screws and nuts.

Ender 3 V2

The new Ender 3 has a diﬀerent display

that inserts into a mounting platform that

also attaches via the two corner

connector screws on the right panel.

Rather than use the 12mm M4 screws as

before, you'll use the longer 16mm M4

screws to attach both the corner

connector and the display mount.