3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 설치 매뉴얼 - 페이지 7

{카테고리_이름} 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 페이지.
3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

The front should look like the picture to the right. 

Locate the magnetic latches and use the wood

screws to attach them to the latch mounts. Hand tighten and

make sure they're secure, but do not over tighten or they may

strip. The latch can be later adjusted front-to-back to make

sure the door is ﬂush with the door frame.

Each latch mount is attached via three screws.

Two M4 12mm cap heads are used to attach the

latch mount to the side, while a 30mm cap head

secures the latch mount to the door frame.

Attach the hinges to the door and door frame

using M4 12mm screws and nuts. There will be

some play in the hole size so that you can adjust

the door to swing freely.

acrylic at the location of each latch. Then, adjust the width of the metal strike plate so

that it is held on by the pressure of the two sides of the plate. The adhesive covering

will keep the metal strike plate from scratching the acrylic.

Attach the door knob by ﬁrst

inserting the square M4 nut

into the slot. Use a 16mm cap

head screw to attach the door.

Now that the latches are mounted it is time to connect the strike

plates. Each plate comes with a squishy adhesive covering the

same size of the plate. Carefully attach the adhesive side to the