esera automation 11320 사용자 설명서 - 페이지 2
{카테고리_이름} esera automation 11320에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. esera automation 11320 8 페이지. 1-wire controller 1 rs232
페이지 인쇄Power supply
For power supply, the 1-Wire Controller 1 has a wide range input of 9 - 30VDC and is therefore equally
suitable for 12V and industrial 24VDC supplies. Suitable DIN rail or plug-in power supplies can be found in
our webshop.
Commissioning
How to videos for commissioning and configuration can be found on our website
Service and Support, How to and Support Videos.
Note: For basics and tips on the 1-Wire bus system, please visit the ESERA Online Shop at
1-Wire basics or please refer to our eBook in the shop under Training/Documentation
3
Technical data
Serial interface (V24 Standard)
connection:
interface:
connection cable:
supply voltage:
current consumption
power supply RTC:
firmware update/
configuration
1-Wire interface:
protection circuits:
connection:
output voltage:
isolation:
4
Ambient conditions
Temperature,Operation -15°C to +55°C
Air humitidy:
Protection system:
Protection class:
Dimensions:
5
Conformity
EN 50090-2-2
EN 61000-4-2, ESD
EN 61000-4-3, HF
EN 61000-4-4, Burst
EN 61000-4-5, Surge
EN 61000-6-1, Interference immunity
EN 61000-6-3, Interference radiation
RoHS
6
Display LED
The module has various display LEDs. In the following the function of the displays
Display
LED Green
LED Green
LED Green
Data interface
LED Green
Data interface
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA-Automation or E-Service GmbH. Errors and technical modification subject to change. ESERA-Automation, E-Service GmbH 2020
www.esera.de
D-SUB 9 PIN plug
RS232 UART Level (+/-3-12 V)
„Null modem cable" (Article No.43004) available in the Shop
9-30VDC
max. 500mA
Goldcap, Buffering of the internal clock (RTC) for approx. 2 days in case of power supply
failure. In case of a longer failure the RTC must be reset. The Goldcap is charged after
approx. 2 hours.
ESERA Config Tool III
1-Wire Bus (+5V, ground and data)
ESD and reverse polarity protection
Screw terminals (up to 2,5qmm cable cross section)
+5V (+/-10%), max. 200mA, overload and short circuit proof
Galvanic isolation between Ethernet and 1-Wire interface
10 - 92% (non condensing)
IP20
III
35 x 90 x 70mm (WxHxD)
Designation
Function
PWR
Display for supply voltage
DATA
Network Link LED,
Lights up when a network connection is established
Network Data LED
Lights up during data communication via the data interface
11320 V1.0 R1.0 Manual
after switching on the device the LED flashes 3x
flashes during 1-Wire activity
flashes when sending data via the data interface
flashes very quickly if "CAL Receive" has been
activated and the "CAL messages" of the control
system are missing.
www.esera.de
at
Page 2 of 8