3DUpFitters FT-5 Enclosure Kit 설치 매뉴얼 - 페이지 8

{카테고리_이름} 3DUpFitters FT-5 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters FT-5 Enclosure Kit 16 페이지.

Left Side Panels

The installation of the left side panels is possible because the left side aluminum braces have

already been loosened. Other braces may need to loosened, though, in order to insert both the

upper and lower left side panels.

1. Installing Left Bottom Panel

The left bottom panel is unique because it has a cutout to insert the power supply

cable in the bottom left corner. The power supply cable should have been removed

before starting the installation. Slide the loosened vertical 20x20 panel out of the way

so there is enough room to slide the panel into place. You may have to loosen or

remove other parts of the braces to make it ﬁt both horizontally and vertically. Do not

confuse this panel with the one for the opposite side, which has a square hole for

the USB port. They are similar but not identical.

The bottom of this panel will rest near the screws holding the bottom melamine (R1) or

aluminum (R2) bottom plate. Depending on how the horizontal 20x20 brace is located

there will either be room for the panel to sit on top of the screws, OR to either side with

a slight bend.

Bottom Left Side Panel Outline