esera automation 19200 VNC IPS 사용자 설명서 - 페이지 2
{카테고리_이름} esera automation 19200 VNC IPS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. esera automation 19200 VNC IPS 5 페이지.
페이지 인쇄
4
Commissioning
Please start with the commissioning of ESERA-Station 200 with the 1-Wire Gateway. To do so, connect to the
Config Tool 3 via USB cable, which you can download from our website. Here you will find the Config Tool 3:
https://www.esera.de/produkte/software/downloads-firmware-1-wire-controller-1-wire-gateway/
Important:
Please start updating the time and date when
commissioning the 1-Wire gateway.
For more details on commissioning, please refer to
the "How To" videos on our website, here:
https://www.esera.de/service-support/how-to-
support-videos/
5
VNC Access
You can directly access the ESERA-Station via VNC. The thinghtvnc is pre-installed on the ESERA-Station.
For access via PC, we recommend the free UltraVNC.
Here you will find the Ultra VNC Software:
You can find installation instruction here:
6
Access data
Below are the access data for accessing the Linux operating system
User:
pi
Passwort:
esera
SSH Access (Default disabled)
User:
pi
Passwort:
eserassh
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH, ESERA-Automation 2020
www.esera.de
http://www.uvnc.com/home.html
http://www.uvnc.com/install/installation.html
19200 V1.0 R1.0 Commissioning I
Access data:
To connect to the ESERA-Station, enter the
IP address and "1".
(IP address:1)
Password: eseravnc
The resolution is fixed at 1280x800 by default.
After you have logged in, please set a new
password
New password for the VNC access:
Start the LX Terminal and enter the
command:
vncpasswd
Page 2 of 5