3DUpFitters Prusa i3 MK2 설치 매뉴얼 - 페이지 7

{카테고리_이름} 3DUpFitters Prusa i3 MK2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Prusa i3 MK2 11 페이지. Enclosure kit
3DUpFitters Prusa i3 MK2에 대해서도 마찬가지입니다: 설치 매뉴얼 (18 페이지)

페이지 인쇄

2. Attach Left Side

The left panel is distinguishable by its

small hole for a cable grommet, in

addition to having "left side" written on

it. Insert the grommet as pictured

before attaching the front of the left-

side to the door frame.

3. Assemble Back

The view to the right is the back panel of the

regular Prusa enclosure when viewed from

behind. The MMU2S version adds two rubber

grommets (not shown) for the PTFE tubes to ﬁt

through.

The four corner connectors are mirror images of

the front.

On the top and on each side are "mid panel

corner connectors", which are basically simple

L-shapes.

The large hole is either for a fan by itself, an air ﬁlter (purchased separately)/fan combo,

or it can be covered up by a plastic disk depending on how much air ﬂow you want.

Note that the fan, either by itself or paired with the ﬁlter or vent is necessary to draw air

over the power supply. This both heats up the air inside the enclosure AND cools

down the power supply, which extends its life. Only use the circular disk to cover up

the hole if you have moved the power supply

outside of the enclosure, or if you simply don't

care about power supply longevity.

Conﬁrm the direction of the fan's air ﬁlter by

plugging it into a USB power supply before

attaching to the ﬁlter and back of the enclosure.

The fan should be oriented to pull air OUT of