Division 6 Dual Mini Sequencer 사용 설명서 - 페이지 14

{카테고리_이름} Division 6 Dual Mini Sequencer에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Division 6 Dual Mini Sequencer 14 페이지.

With 1X disabled, the sequencer will loop internally at the end of a sequence (or song) without

needing to receive a gate pulse in XP IN. It will still respond to incoming pulses, however.

RUN/RESET

This is another mode you can enable for XP IN. In this mode, the sequencer starts when XP IN

goes high and resets when it goes low. You can use this mode to both start and stop the

sequencer, or start it from a step other than 1 (select your starting step with the buttons, then

send a gate pulse to XP IN).

To toggle this mode, press and hold PROG/RESET then RUN (just like for 1X mode), then hold

them for about 1 second. The clock LED will blink twice for enabled and flicker dimly for

disabled.

Note: If you enable this mode but don't have anything plugged into the XP IN jack, the

sequencer won't loop properly when it reaches the end of a sequence since XP OUT is cascaded

to XP IN (the XP pulse will just trigger a reset).

CLOCK OUT

You can set the sequencer to send the internal clock out the ACC jack. Press and hold

PROG/RESET, then ACC, then hold the button combination for 1 second. The ACC LED will blink

twice to let you know that CLOCK OUT is enabled and will flicker dimly when it has been

disabled.

ACC will no longer be sent out this jack, but it can still be programmed into sequences. The ACC

jack will still operate normally when using an external clock.

CHANGE ON CLOCK mode

Normally if the sequencer is running and you select a new song or sequence to play, it waits

until the current one has completed before switching to the new one. You can change this so

that the song or sequence is switched on the next clock by enabling CHANGE ON CLOCK mode.

To enable this mode, press and hold PROG/RESET, then STEP UP, then hold both buttons for 1

second. The STEP 15 LED will blink twice for enabled and flicker dimly for disabled.