3DUpFitters CR-10 S5 설치 매뉴얼 - 페이지 15

{카테고리_이름} 3DUpFitters CR-10 S5에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters CR-10 S5 15 페이지. Enclosure kit

Tool Holder

Our favorite customization is

to add magnetic tool holders

to the side. One end can be

attached via the same hole as

the corner connectors, but the

other end will require drilling a

single hole.

Upgraded Bed Heaters

The next most common modiﬁcation is a better heater bed, including the 120V bed. Not only

does the 120V version heat up faster than the hot end, it will go up to 120C so you can print

ABS. The key to doing this mod with an enclosure, is to make sure you adjust any cable

holders for the bed heater to not stick out the rear as on the stock heater. We have ours

adjusted to completely ﬁt under the bed, giving the maximum front to back room in the

enclosure.