CamJam EduKit 3 조립 지침 매뉴얼 - 페이지 2

{카테고리_이름} CamJam EduKit 3에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CamJam EduKit 3 6 페이지.

4. Apply steel ball assembly to the box bottom over the 2

of assembly will be approximately 7/8" from front of the box, centered side to side.

5. Cut 3/8" x 3/8" piece of 3M tape and apply to optical sensor over hole in circuit board.

6. Peel and stick optical sensor to box bottom so that sensor is in the hole and circuit board pins

point directly to back of box.

7. Install 4 each of AA batteries in battery box and turn switch "OFF".

8. Cut 2 each of 1" long mated Velcro.

9. Apply Velcro to battery box on the side which has "OPEN". Ensure there is at least 1/2" gap

between the Velcro pieces.

"o" in the "Robotics" label. The center