Camlab 1200464 사용자 설명서 - 페이지 10

{카테고리_이름} Camlab 1200464에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Camlab 1200464 14 페이지. Round ceramic coated steel hotplate/stirrer with led display

Characters

HOT

Warning:

Residual heat warning does not function when unit is turned off using

the switch. It is advisable to turn functions off using dials until unit

has cooled sufficiently and unit no longer displays 'HOT' before

powering off fully.

Instructions for use

1. Set up the instrument in an appropriate location and connect to a power

supply. Switch the unit on using the switch located on the side of the unit –

labelled as (2) on figure 2a.

2. Fill an appropriate heat resistant vessel with the liquid to be stirred and/or

heated and place on the work plate. If you are using the stirring function, add

an appropriate magnetic stirring bar.

3. Heating. Rotate the temperature dial (labelled (1) on figure 2) clockwise to

your desired target temperature and push in the dial to commence heating. To

turn heating off, push the dial in again. When heating is not in use, the

temperature LED will display as 'OFF'.

4. Stirring. Rotate the dial to your set speed and push in to turn the function on.

It is advised to start the speed slowly and gradually increase as required, this

will allow for stable operation with the stir bar. To turn stirring off, push the dial

in again.

5. When finished, ensure each dial is pushed in and the LED displays 'OFF' for

both temperature and speed. Use the ON/OFF switch located on the left hand

side and unplug from the mains supply.

The external temperature sensors Pt1000 can be used as an accessory to this

instrument and allows for more accurate monitoring of the temperature of the liquid

being heated. When an external temperature sensor is used, the tip of the measuring

sensor must be at least 5-10mm from vessel bottom and wall.

1. Ensure unit is fully powered off prior to plugging in temperature probe.

2. Attach the probe holder to the probe holder port. Plug the probe into the probe

Residual heat warning, displays HOT when temperature is

Probe icon to left of the LED display area is lit when a

PT1000 is plugged into the instrument.

Description

above 50°C