Camlink CVACC-G685 사용자 설명서 - 페이지 4

{카테고리_이름} Camlink CVACC-G685에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Camlink CVACC-G685 8 페이지.

페이지 인쇄

Negatives

Slides

(2\

(1)

-_(r,ry____-___-_______

(2)

(1) Hold up

the

negative toward

the

light. As you look through

the

negative,

(1) Hold up the slide toward

the

light.

Fae

the trademark stide

ofthe

slide

away

from

you. Look through the slide and it should

appear nomally

(not a

mirror image). Now turn the slide so

the

image is upside

dom

while lmking

at the same side.

(2) Open the slide holder at

the

marked spot on the top. With the stide

hotder

laid

open

place

the

slide into

reessed

area

the holder

the

slide

should

lit

perfectly.

Note: Handle slides with care. Any dust, Scratches

orfinger

prints

will show

up on your

saved

images. lf possible, use cotton gloves wtren handing

slides. lt is recommended to use compressed air to remove any dust on

the

slides. This is not included with the film

senner

but

be purchased from

an office supply or

electroni6

retailer.

you should be able

read

the

smail

neg"tir"

nurO"o

io*"fiy

t""i

mirror image).

Now turn the negative so the image is upside

down while looking at the

same side.

(2) Open the negative holder at

the

marked spot on the top. With the

negative holder

raid

open prace

the

negative into horder so

the

notches

rine

up with

the

notches on the holder.

Note:

Handle negatives with

mre.

Any dust, scratches or finger prints

will show up on your saved images. lf possible

use

cotto,

gf;r"J*i*

nandting

negatives.

lt is re@mmended

use

compressedlir to

remove any dust on

the

negatives,

This is not included with the tilm scanner but

can be purchased from an

office supply or

electronic

retailers.

(4)

(3)

(4\

(3)

(3) Close

the

slide holder and press

the

edges so that it locks in place.

(4) Hold it

the

position as showing the

film smnner

lnsert the Slide Holder into the slot on

the

righl side of the film

s€nner

shown.

(3) Close the

negativ€

holder and press the edges so

that

locks

place.

Hold it in

the

position as shown

the

film

scanner.

(4)

lnserl

the negative holder into the slot on

the

right side

ofthe flm

scanner as shown,

Film HoldeE:

The design

offilm

holder

follow ISO standard. ln some @ses,

the holes on the film will not match exacdy to

alignment

ofthe

holder. This

caused

a non-standard camera. ln this case, there

will be a small black line

.^-the

edge

ofthe fEme

that can easily

cropped out usihg photo editing software.

lsontemational

Organization for

Standardiation