ESI ePhone4x 지침 - 페이지 15

{카테고리_이름} ESI ePhone4x에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ESI ePhone4x 19 페이지. Button programming
ESI ePhone4x에 대해서도 마찬가지입니다: 빠른 시작 Quide (2 페이지)

Programming Multicast Paging

The ability to configure Multicast Paging within Auto Provisioning is included in an upcoming system firmware build that

is currently being evaluated for release. However should you need to configure this feature before it is available due to

the 10 phone limit per Page Group, we will cover it here.

First each phone you are adding to the page group(s) will need to be configured to Subscribe to the Multicast

Channel(s) associated to the Group(s). This is programmed in the Phone GUI in the Phone Settings > MCAST (See

screenshot below:)

Here the first Index/Priority has been configured. The Name is: PG1 and the Host:Port is: 224.123.123.123:6767. Once

your phones are Subscribed to the Multicast Channel, you will need to program a Multicast Button on your phone to

Access this channel.

The Multicast Button Type allows the Phone to access the subscribed Multicast Channel and select the Voice Codec to

use. The advantage of using the phones' Multicast feature is that there are no system resources used to provide this

function and there is no SIP messaging used to activate it.

Here we will program a Button on the ePhone4x for the Multicast Paging Access we programmed above. In the

screenshot below, we have chosen button: DSS Key 1-9 and have named it: "Paging". The value is the Multicast IP

Address and Port programmed: "224.123.123.123:6767" and the G.722 Codec has been selected for the Voice.

Page 15 of 19

0455-0209 Rev C