DIW RST602R 지침 - 페이지 2

{카테고리_이름} DIW RST602R에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DIW RST602R 2 페이지.

페이지 인쇄

Instructions for the touchShade switch DTRS-500

(RST602R)

Intended Use:

Roller blind switch DTRS-500:

The roller blind switch DTRS-500 is a switch for radio control of tubular

motors, awnings, blinds, etc. The functions are UP - STOP - DOWN

connection and assembly

Safety instructions for DTRS-500

In order to avoid electric shock, please only have it connected by a

specialist!

Make sure the neutral wire and live wire are properly connected.

- Strip the solid wires (solid conductors only) at least 7 mm and connect the

wires according to the diagrams below; ensure terminals are properly

tightened and no bare wire is visible.

- Suitable wire diameter for the terminal is 0.75mm²~ 2.5mm²

Danger! A terminal block cannot hold 2 pieces of

2.5mm² wire at the same time!

Teaching the DTRS-500

first use and connection/paring

The display of the UP and DOWN buttons

flashes simultaneously after switching on.

The device is then in learning mode.

Press the UP or DOWN button for about 4

seconds. After the button indicator

flashes, press and hold the ON button on

your transmitter until the indicator stops

flashing. The device is then trained and

ready for use.

Reset DTRS-500

After turning it on, press and hold the button on the control panel until the

indicator starts flashing. Then press and hold the OFF button on your

transmitter until the display stops flashing, then release the OFF button.

The device was thus reset.

Specification DTRS-500

Operating voltage: 230V/50Hz

Motor load: Max.500W

Frequency: 433.92MHz

Ambient temperature: 0-35°C

Size: 80x80x37.5mm

DTRS-500 Changing the direction of movement of the motor

Normally, pressing the UP button makes the motor go up, pressing the

STOP button stops the motor, and pressing the DOWN button makes the

motor go down. If you want to change the moving direction of the motor,

you just need to press the UP and DOWN button together more than three

seconds and the motor will run reversed.

Controlling the engine with the remote control

When the motor is off, press the ON button on the transmitter, the motor

rotating direction is ↑, press the OFF button on the transmitter, the motor

rotating direction is ↓ When the motor is in the ↑ state, first press the OFF

button to stop the motor, and then press the OFF button again to change

the motor rotating direction to ↓. When the motor is in ↓ state, first press the

ON key to stop the motor and then press the ON key again to change the

motor direction of the motor to ↑.

Reproductions of any kind require the written permission of the publisher.