ESI KATA2-MS-GM-SLV 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} ESI KATA2-MS-GM-SLV에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ESI KATA2-MS-GM-SLV 8 페이지. Dual monitor arm with sliders
페이지 인쇄
Kata2-MS
If using optional grommet mounting method:
• Replace step 1 with steps A and B on page 7. Then return to this page and start with step 2 below.
Step# 1: clamp base assembly to worksurface
The thickness of the worksurface must be between 0.5" and 2.1".
• Loosen the clamp sufficiently to be able to slide it easily onto the worksurface.
• Clamp the assembly to the worksurface in the desired position. Be sure to
tighten the clamp securely.
Step# 2: assemble slider mounts
IMPORTANT: When assembling the slider mounts, the groove on the slider bar must be at the bottom.
• Slide the VESA mount assembly onto the slider bar. Center the assembly on the slider bar.
• Install the M4x9 set screw into the bottom of the VESA mount assembly. Using the 2mm Allen key, tighten the set screw to hold the assembly in place. Be sure the
screw tip fits into the groove on the slider bar.
— After the monitor has been installed, the VESA mount can be moved anywhere along the slider bar by loosening the locking screw no more than one full turn, so that
it stays inside the groove. Be sure to re-tighten the screw to secure the monitor in the desired position.
VESA mount
assembly
slider bar
clamp to
worksurface
2mm
Allen key
Page 3
Assembly
groove
slider mount set screw
M4x9
0.5" – 2.1"