ESI Enmo 2NM-C48-WHT 조립 및 작동 지침 매뉴얼 - 페이지 7
{카테고리_이름} ESI Enmo 2NM-C48-WHT에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ESI Enmo 2NM-C48-WHT 12 페이지. Electric height adjustable table base
페이지 인쇄
Enmo
Step #7: if optional caster kit was ordered, install casters
• Remove the two glides attached to each foot.
— Unscrew the glides to remove them.
• Attach two casters to each foot.
— Screw in the casters by turning the stem nut on each caster clockwise.
— Secure the casters in position by tightening the nuts using a 12mm wrench.
Step #8: attach control unit and handset
• Attach the control unit to the worksurface with two ST4.8x19 self-tapping screws.
— Position the control unit on the rear side of the frame's cross channels in a location where 1) its ports can be reached by the cables from the legs and handset,
and 2) the power cord will be convenient to an outlet or power strip.
• Attach the handset to the worksurface with two ST3.5x19 self-tapping screws.
— Position the handset flush with the front edge of the worksurface, on the left or right side according to user preference. Be sure the cable can reach its port on
the control unit.
control unit
ST4.8x19
unscrew glide
handset
Page 7
stem nut
screw in
caster
remove
glide
ST3.5x19
Assembly
tighten with
12mm wrench