ESI FLEX2-SLV 사용 설명서 - 페이지 7
{카테고리_이름} ESI FLEX2-SLV에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ESI FLEX2-SLV 12 페이지. Electric table base
페이지 인쇄ASSEMBLY
STEP 13
Attach the control unit bracket to the frame and
the control unit to the work surface.
• Secure the control unit bracket to the frame using
two M6x8 screws and a 4mm Allen key.
• The bracket may be attached on either side of
the frame. (Note that the digital keypad will be
attached on the same side.)
• Attach the control unit under the bracket using
M5x18 wood screws. The motor cable and
keypad ports should face the center of the table,
as shown.
• Allow 2¼" (57mm) between the back of the
control unit and the top support to allow room for
power cord attachment.
STEP 14
Attach the digital keypad at the front edge of the
work surface.
• Use the two M4x25 wood screws.
• Attach the keypad on the same side as the
control unit.
STEP 15
Make connections to the control unit.
• Connect the cable from the digital keypad.
• Connect the motor cables from the motors.
• Connect the power cord to the control unit.
• Plug the power cord into an AC outlet.
CAUTION: Do not operate the table until after
"zero setting" the system. See following step.
ALL-FLEX
M5x18
2¼"
Bracket
Digital
Keypad
Power
Cable
Control
Unit
ELECTRIC TABLE BASE
™
M6x8
Control
Unit
M4x25
Motor
Cables
Keypad
Cable
7