ClearMirror Shower ClearMirror Series 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} ClearMirror Shower ClearMirror Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearMirror Shower ClearMirror Series 6 페이지. Fog-free shower mirrors
페이지 인쇄WARNING: This stage requires a qualified electrician and conformance with both the National
Electrical Code and local building codes. Turn off the power to the circuit connected to the light
fixture at the disconnect means. Failure to do so could result in death or serious injury.
JUNCTION BOX AND WIRING
Observe electrical load requirements. Ensure total amperage does not exceed rating of
the wall switch (i.e. 15-amp switch), circuit or existing wiring.
Use minimum 18-gauge wire from transformer to Shower ClearMirror connection.
1. Run power supply wires from the provided low-voltage transformer to the opening at
the mirror location. The power supply wires are run in the wall (see Figure 1).
2. Ensure low-voltage junction box is installed per manufacturers instructions.
3. Install wallboard and cut out opening for the junction box.
NOTICE: Junction box must be accessible per all applicable safety, local, and national electrical
codes. Access to the junction box is gained by removing the mirror.
NOTICE: Transformer must be accessible and must have air flow. Never put a transformer or
outlet In a closed wall.
Low‐Voltage
Junction Box
Figure 1. Locating the junction box and running low-voltage wires from the transformer (front view).
Wall Studs
Switched 120V
Outlet Supply
In‐line
Transformer