ClearNav CNv NavDisplay 매뉴얼 - 페이지 8

{카테고리_이름} ClearNav CNv NavDisplay에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearNav CNv NavDisplay 16 페이지. Display for the cnv variometer with igc logger

CNd Manual

Navigation - Task Editor

The TASK EDITOR is entered by scrolling all the way to the right with the Left

/Right buttons.

The last-entered active task will be displayed ... or a 'No Task' message will be

displayed.

The The Up / Down buttons are used at his point to perform ALL task edit

functions.

New Task Setup

1/ Press the BR encoder to display the list of turnpoints. The bottom

highlighted row of the list will be '<<end>>'

2/ Press the BR encoder again to start new task creation.

3/ The initial task screen will display '**NoTask**' to indicate no turnpoints

have been selected for this new task setup.

4/ Press the BR encoder to display the turnpoint list.

5/ Scroll down the list with the BR encoder to select a Start point. The first

turnpoint selected is always assumed to be the start point and has the prefix

'S:' in the task display.

6/ The task will display the Start at the top of the list and '<<end>>' will be

highlighted on the last line.

7/ Press BR encoder to display turnpoints. BR encoder will scroll through the

list. Press the BR encoder to add the highlighted turnpoint to the task.

8/ The task will be display with the Start ... and the last selected turnpoint as

Finish. The '<<end>>' will be highlighted.

10/ Continue add turnpoints to the bottom of the task using the BR encoder to

scroll and select. The last selected turnpoint is always considered the Finish.

11/ When task construction is completed, depress and hold the BR encoder to

display the save options.

'Cancel' discards the task. The CNv will revert to the last entered task.

'Declare - No' saves the task ... but does not initialize the declaration.

'Declare - Yes' saves the task ... and does initialize the declaration.

12/ When 'Declare - Yes' or 'Declare - No' is selected, the Start turnpoint

becomes the active waypoint.

Active Task Edit

1/ Existing tasks can be edited by changing an existing turnpoint ... or by

deleting all turnpoints at a certain point in the task turnpoint list.