3form Edge SimpleSpec 300.31 설치 매뉴얼 - 페이지 10
{카테고리_이름} 3form Edge SimpleSpec 300.31에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3form Edge SimpleSpec 300.31 12 페이지.
페이지 인쇄
Edge
SimpleSpec 300.31
Installation
9
How to Shorten a Section of Edge Walls
When less than the full width of edge (<42") is needed, you must cut down the rails of the edge product. Follow the
instructions below for best results.
a
Determine the number of fins needed (or your maximum
length). See chart below.
# of Fins
1*
2*
3*
4*
5
6
7
8
*For rails with less than 4 fins, you must drill a new count-
er-bored hole and through hole for the Rampa insert for
expanding the rails.
• First counter-bore with a 1/2" diameter brad point drill
bit to a depth of 3/8" (9.5mm)
• Next drill all the way through with a 1/4" diameter brad
point drill bit
For more information, please visit 3-form.com or call 800.726.0126
June 2021 | MAn-RTG-300-31 | ReV 005 © 2021 3form, Inc. All rights reserved.
Distance
5 1/4"
1 1/2"
15 3/4"
21"
26 1/4"
31 1/2"
36 3/4"
42"
tm
b
If you are mounting next to another assembly of
edge, its important to identify the side of the rails
that will meet up with the existing fins. When you cut
the rail, it will leave exposed wood, so this will need
to be mounted against the existing system. If you are
nOT mounting adjacent to another system, you will
need to paint the side of the rail that is cut.
c
Mark your rail for your desired cut. See dimensions
in Step 9a, based on the number of Fins you want.
d
Install modified rail, with cut side facing existing
edge system.
Installation Manual
1 0