Camoplast Tatou UTV T4S 설치 매뉴얼 - 페이지 12

{카테고리_이름} Camoplast Tatou UTV T4S에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camoplast Tatou UTV T4S 18 페이지. Track system
Camoplast Tatou UTV T4S에 대해서도 마찬가지입니다: 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (15 페이지)

페이지 인쇄

CAUTION: The orientation of the bolt (C)

which secures the stabilizing rod in place is

crucial.

Wrong

breakage of track systems and vehicle

components.

8. Attach the rear suspension stabilizing rod (A) to

the lower hole of the anchor plate (B) using the

bolt (C), bushing (D), washer (E) and nut (F).

Tighten to 50 N•m [37 lb•ft]. Refer to Figure 12.

NOTE: Ensure that parts are assembled in the

correct order.

Figure 12

9. Inspect the rear track systems and ensure that

all mounting bolts were correctly tightened

during installation. Lower the vehicle to the

ground and proceed to install the front track

systems.

Installation Guidelines / Directives d'installation

orientation

can

cause

ATTENTION:

L'orientation des boulons (C)

qui retiennent les bras stabilisateurs est

cruciale. Une mauvaise orientation peut

entraîner des bris aux systèmes et aux

composantes du véhicule.

8. Fixer le bras stabilisateur (A) au point d'ancrage

au bas de la plaque (B) au moyen du boulon (C),

de l'espaceur (D), de la rondelle (E) et de l'écrou

(F). Serrer à un couple de 50 N•m [37 lb•pi]. Voir

la Figure 12.

NOTE : Assurez-vous d'assembler les pièces dans

l'ordre indiqué.

9. Inspecter les systèmes de traction arrière et

s'assurer que tous les boulons ont été serrés

correctement lors de l'installation. Abaisser

ensuite le véhicule au sol et procéder à

l'installation des systèmes de traction avant.

Page 12