Camoplast ATV T4S 설치 매뉴얼 - 페이지 11
{카테고리_이름} Camoplast ATV T4S에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camoplast ATV T4S 19 페이지. Atv track system
Camoplast ATV T4S에 대해서도 마찬가지입니다: 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (15 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지)
페이지 인쇄
9. Attach the stabilizing rod (B) to the anchor
bracket (A), using the spacer bushings (C), the
flat washer (D) and nut (E). Torque to 70 N•m
[52 lb•ft]. Refer to Figure 13.
NOTE: Ensure that parts are assembled in the
correct order.
Figure 13
10. Verify that spring assembly bolt (F) is tightened
to the recommended torque specification: 40
N•m [30 lb•ft]. Refer to Figure 14.
Figure 14
11. Inspect the rear track systems and ensure that
all mounting bolts were correctly tightened
during installation. Lower the vehicle to the
ground and proceed to install the front track
systems.
Installation Guidelines / Directives d'installation
9. Fixer le bras stabilisateur (B) au boulon déjà
installé sur l'ancrage de suspension (A) à l'aide
des espaceurs (C), de la rondelle (D) et de
l'écrou autobloquant (F). Serrer à un couple de
70 N•m [52 lb•pi]. Voir la Figure 13.
NOTE : S'assurer d'assembler les pièces dans
l'ordre indiqué.
10. Vérifier que le boulon du ressort (F) est serré au
couple recommandé : 40 N•m [30 lb•pi]. Voir la
Figure 14.
11. Inspecter les systèmes de traction arrière et
s'assurer que tous les boulons ont été serrés
correctement lors de l'installation. Abaisser
ensuite le véhicule au sol et procéder à
l'installation des systèmes de traction avant.
Page 11