ABC PROIZVOD Concept 2 mini air 기술 지침 - 페이지 13

{카테고리_이름} ABC PROIZVOD Concept 2 mini air에 대한 기술 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ABC PROIZVOD Concept 2 mini air 16 페이지. Central heating cookers

Panel disassembly for cleaning soot below the oven

The place

where to put

a screwdriver

The opening, pos. 10' , F. 7 is designed for cleaning the soot below the oven. The panel is

fastened to a clip and is easily removed by a lever principle (f.e. with a screwdriver). On a suitable

place (F.7, pos. 10), on the bottom of the panel, on the left, there is an opening. Put the

screwdriver is into the opening and place it under the panel by 120 mm, press it down (lever

principle) and the panel will be detached from the clip. Remove the panel gently from the small

column on the right. Remove protective sheet metal and gasket from the opening intended for

cleaning the soot below the oven. When cleaning is complete, replace the gasket, protective

sheet metal and panel.

The cooker cooling by means of watering the firebox is forbidden.

Once the heating season is over, clean the cooker thoroughly and completely. Drain the water

only if some utility repairs are required.

Upon the completion of the heating season, the manufacturer recommends a linen bag with 1-2

kg of grinded quicklime to be suspended within fuel feeding area.

9. DISASSEMBLY AND DISPOSAL

At the end of the product's life, remove power supply, water supply and heating connections,

drain water and handle the product to an authorized waste collection/recycling point.

In compliance with the European Directives, the symbol of "crossed recycle bin" (see the Figure

on the right) warns you that you are committed to treat unusable products with a special attention.

Picture number 7

Plating

Carrier

Screwdriver for removal of plating

Detail A