ClearOne XAP TH2 설치 및 운영 매뉴얼 - 페이지 11
{카테고리_이름} ClearOne XAP TH2에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearOne XAP TH2 20 페이지. Telephone interface
ClearOne XAP TH2에 대해서도 마찬가지입니다: 데이터시트 (2 페이지)
페이지 인쇄CHAPTER 2: Installation
Hardware Setup
The XAP TH2 is designed for easy installation and setup. All connections are made
through rear-panel connectors.This section provides instructions on installing the
units in the rack and making initial connections, assigning device ID numbers, and
creating an expansion bus (E-bus) network.
The diagram below illustrates the typical connections that are made when
adding a XAP TH2 to a XAP 800.
Connecting the unit
Refer to XAP TH2 rear-panel drawing on the following page. Each connector is
numbered for easy identification.
1.
Place the unit in the rack and attach it securely. XAP TH2 models are
designed for installation in a standard 19-inch equipment rack.
2.
Connect your telephone line from the wall jack to the RJ-11C Line jack [B].
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Figure 2.1. System diagram