Camoplast ATV T4S 설치 매뉴얼 - 페이지 16
{카테고리_이름} Camoplast ATV T4S에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camoplast ATV T4S 20 페이지. Atv track system
Camoplast ATV T4S에 대해서도 마찬가지입니다: 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (15 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지)
페이지 인쇄
4. Remove the bolt, washer and bushings from the
front stabilizing rod end and insert the bolt in the
front anchor bracket as shown in Figure 22.
NOTE: It is not possible to insert this bolt once the
bracket is attached to the vehicle's
suspension arm.
Figure 22
5. Position the bottom part of the anchor bracket
(2-3) under the lower suspension arm. Position
the top part (4-5) over the suspension arm.
Insert the M10x65 mm bolt (6) through the top
and secure the two parts together with the nut
(7) provided. Tighten assembly to 50 N•m [37
lb•ft] of torque. Refer to Figure 23.
Figure 23
Installation Guidelines / Directives d'installation
4. Enlever les boulons, les rondelles et les
espaceurs des rotules des bras stabilisateurs
des systèmes avant. Insérer un boulon à
l'extrémité
de
chacun
suspension avant. Voir la Figure 22.
NOTE : Il est impossible d'insérer ce boulon une
fois l'ancrage fixé au bras de suspension
du véhicule.
5. Positionner la partie inférieure de l'ancrage
anti–rotation (2-3) sous le bras de suspension
inférieur. Positionner la partie supérieure (4-5)
au–dessus du bras de suspension. Insérer le
boulon M10x65 mm (6) par le dessus de
l'ancrage. Assembler les deux parties avec
l'écrou (7) fourni. Serrer l'assemblage à un
couple de 50 N•m [37 lb•pi]. Voir la Figure 23.
Page 16
des
ancrages
de
©2016 Camso inc.