Camoplast ATV T4S 설치 매뉴얼 - 페이지 10

{카테고리_이름} Camoplast ATV T4S에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camoplast ATV T4S 15 페이지. Atv track system
Camoplast ATV T4S에 대해서도 마찬가지입니다: 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

7. Attach the stabilizing rod (B) to the anchor

bracket (A), using the spacer bushings (C), the

flat washer (D) and nut (E). Torque to 70 N•m

[52 lb•ft]. Refer to Figure 10.

NOTE: Ensure that parts are assembled in the

correct order.

Figure 10

8. Verify that spring assembly bolt (F) is tightened

to the recommended torque specification: 40

N•m [30 lb•ft]. Refer to Figure 11.

Figure 11

9. Inspect the rear Track Systems and ensure that

all mounting bolts were correctly tightened

during installation. Lower the vehicle on the

ground and proceed to install the front Track

Systems.

Installation Guidelines / Directives d'installation

7. Fixer le bras stabilisateur (B) au boulon déjà

installé sur l'ancrage de suspension (A) à l'aide

des espaceurs (C), de la rondelle (D) et de

l'écrou autobloquant (E). Serrer à un couple de

70 N•m [52 lb•pi]. Voir la Figure 10.

NOTE : Assurez-vous d'assembler les pièces dans

l'ordre indiqué.

8. Vérifier que le boulon du ressort (F) est serré au

couple recommandé : 40 N•m [30 lb•pi]. Voir la

Figure 11.

9. Inspecter les systèmes de traction arrière et

s'assurer que tous les boulons ont été serrés

correctement lors de l'installation. Abaisser

ensuite le véhicule au sol et procéder à

l'installation des systèmes de traction avant.

Page 10