Camoplast ATV T4S 매뉴얼 - 페이지 10

{카테고리_이름} Camoplast ATV T4S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camoplast ATV T4S 16 페이지. Atv track system
Camoplast ATV T4S에 대해서도 마찬가지입니다: 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (15 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (16 페이지)

7. Attach the rear suspension stabilizing rod to the

undercarriage bracket using washers (A),

bushing (B) and nut (C). Use lower hole. Refer

to Figure 14.

Figure 14

8. Secure the undercarriage to the rear hub using

the nuts (16) provided. Refer to Figure 15.

NOTE: If needed, take rubber protector off of hub.

NOTE: Ensure that the cotter pin of the axle nut

does not interfere with the undercarriage

hub.

NOTE: Use torque specification indicated by the

vehicle's manufacturer when tightening

wheel nuts.

Figure 15

Installation Guidelines / Directives d'installation

7. Fixer le bras stabilisateur au trou du bas de la

pièce d'ancrage du système de traction au

moyen des rondelles (A), de l'espaceur (B) et de

l'écrou (C). Voir la Figure 14.

8. Fixer le système de traction au moyeu de roue

arrière, utiliser les écrous (16) fournis. Figure 15.

NOTE : Retirer le protecteur en caoutchouc du

moyeu, s'il y a lieu.

NOTE : Assurez-vous que la goupille fendue de

l'écrou de l'essieu n'interfère pas au coeur

du moyeu du système de traction.

NOTE : Serrer les écrous de roue au couple

indiqué par le fabricant du véhicule.

Page 10