3form SimpleSpec 300.01 설치 매뉴얼 - 페이지 6
{카테고리_이름} 3form SimpleSpec 300.01에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3form SimpleSpec 300.01 10 페이지.
페이지 인쇄
Ready To Go
SimpleSpec 300.01
Installation
2
Drill and Attach Anchors cont...
g
Hollow Substrate Installation
Metal
Studs
Drill Ø3/4" (19mm) hole. Minimum
clearance behind wall = 17/8" (48mm)
j
Slide the plastic cap forward along the
legs until it is seated flush to the work
surface.
For more information, please visit 3-form.com or call 800.726.0126
April 2018 | MAN-rTG-300-01 | rEV 002 © 2018 3form, inc. All rights reserved.
tm
h
position the metal channel parallel
with the plastic legs. insert the metal
channel through the drilled hole into
the wall cavity.
k
Snap the plastic legs off flush at the
plastic cap by pushing outward.
Installation Manual
i
Metal
Studs
pull the metal channel firmly against the
inner wall cavity by tugging the plastic
pull ring.
l
Note: Maximum torque on screw or rod
is 5 ft-lb.
6