1 BY ONE H005 사용 설명서 - 페이지 6

{카테고리_이름} 1 BY ONE H005에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 1 BY ONE H005 14 페이지. Belt drive turntable system

페이지 인쇄

Anti-skating Force Adjustment

The anti-skating force must be adjusted corresponding to the tracking force as follows:

Tracking Force

Groove in the stub

5-10 mN

1st from bearing ring

10-15 mN

2nd from the bearing ring

15-20mN

3rd from the bearing ring

20mN and larger

4th from the bearing ring

1. Slip the loop of the anti-skating weight's thread over the

set the correct anti-skating force for the factory-fitted cartridge.

2. Feed the thread through the hook of the wire support.

Installing the Lid

Lid carefully over the hinge prongs.

Install the

④ ③ ② ①

3rd groove of the stick to

Setting Phono-Line Out Switch

This product has a built-in phono equalizer function. You can use the turntable, even

if you do not have a phono amplifier or connectable equipment with a built-in phono

amplifier.

Phono-Line Out Switch to set the output, as shown below.

Use the

Connectable device being used

Device with phono input

Device without phono input

Connection to an Amplifier (Device with Phono input, PHONO mode)

This turntable uses a moving magnetic cartridge. Set the

on PHONO mode. Connect the phono out cables to the phono input on your amplifier

Line inputs such as CD, Tuner, Tape, or Video are

of pre-amplifier (phono stage).

not suitable for phono inputs. Make sure the amplification of the selected input

matches the type of cartridge being used. The factory installed cartridge is 47k ohms /

MM-input.

NOTE: If your amplifier does not have an input suitable for phono cartridges, you

will need to purchase a separate phono amplifier for moving magnetic cartridges.

This separate phono amplifier will then connect between your turntable and your

amplifier.

Stereo System Connection (Device without phono input, LINE mode)

PHONO & Line Out Switch to LINE mode. The RCA PHONO & Line Out

Set the

Jacks output analog line-level signals and can be connected directly with a pair of

active/powered speakers of the appropriate input of your stereo system.

The Red plug connects with the Right channel and the White plug connects

with the Left channel.

NOTE: The RCA Jacks are not designed to be connected directly to passive/

unpowered speakers in LINE mode. If connected to the passive speakers, no sound

will come out.

Main Power Connection

Unpack the power adapter from the foam packing material and plug the small end

DC power jack located on the back of the turntable. Plug the power adapter

into the

plug into an electrical outlet.

Position of Phono-Line Out Switch

Phono

Line

PHONO & Line Out Switch